Use cylinder block pressure test kit (J–36223–D) for immersion method pressure testing as follows: 1.Install cylinder liners with new seal rings and crevice seals. Refer to section 1.23.3. Seat the liners firmly in the block counterbores with cylinder liner installation tool (J–35597–A). 2.Install two metric eye bolts (J–35595) in the head bolt holes at opposite… Read More »
Before removing cylinder liners for block cleaning, the liner bores should be gaged to determine whether liner replacement is necessary. Refer to section 1.23.2.2. Remove cylinder liners with the cylinder liner removal tool (J–45876) before putting the block in cleaning or descaling baths, to avoid trapping cleaning agents in block liner seating bores. See Figure… Read More »
Before mounting an engine on an overhaul stand, it must be disconnected from the transmission. Details for removing an engine will vary from one application to another. However, the following steps will be necessary, regardless of application: 1. Disconnect the battery cable(s) from the battery(s). 2. Drain the cooling system completely by removing the drain… Read More »